Replacing The Controller From Vertical Mounting Kit To19" Rack Mounting Kit - ABB OmniCore C30 Product Manual

3 Installation and commissioning

3.4.4 Replacing the controller from vertical mounting kit to19" rack mounting kit

3.4.4 Replacing the controller from vertical mounting kit to19" rack mounting kit
General
If the 19" rack mounting kit and vertical mounting kit are purchased at the same
time, the controller will be mounted with vertical mounting kit when delivered to
the customer from ABB. The vertical mounting kit can be removed and replaced
with the 19" rack mounting kit.
Required equipment
Equipment
Mounting kit
Standard toolkit
Removing the vertical mounting kit
Use this procedure to remove the vertical mounting kit from the controller.
1
2
3
Continues on next page
68
Action
Remove the screws.
Remove the support foot units.
Refit the screws.
© Copyright 2019-2022 ABB. All rights reserved.
Information
3HAC063918-001
See Standard toolkit for controller on
page 570.
Info/illustration
B
A
xx1800000458
A Support foot unit, 2 pcs
B Torx countersunk screw M4x10 (4
pcs)
Tightening torque: 1.7-1.8 Nm
Product manual - OmniCore C30
3HAC060860-001 Revision: P