Safety During Operation - ABB OmniCore C30 Product Manual

1.6 Safety during operation

Automatic operation
Verify the application in the operating mode manual reduced speed, before changing
mode to automatic and initiating automatic operation.
Lock and change of operating mode
To prevent hazard, it is the responsibility of the integrator to make sure that keys
used to lock or change the operating mode are handled only by authorized
personnel.
Safety devices not in use
Safety devices that are not connected to the robot or robot system cannot initiate
a protective or emergency stop. These must be stored out of sight so that they
cannot be mistaken for being in use.
Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
1 Safety
1.6 Safety during operation
33