ABB OmniCore C30 Product Manual page 476

5 Repair
5.3.7 Replacing the IP20 power outlet connector
Continued
Required tools and equipment
Equipment
Standard toolkit
ESD protective wrist band
Required documents
Document
Circuit diagram - OmniCore C30,
Circuit diagram - OmniCore C30
for IRB 14050, Circuit dia-
gram - OmniCore C30 for CRB
15000
Removing the IP20 power outlet connector
Preparations
1
2
3
Continues on next page
476
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 47.
Remove the top and right covers and the
front panel of the controller.
© Copyright 2019-2022 ABB. All rights reserved.
Article number Note
- Content is defined in section
Standard toolkit for controller on
page
-
Article number Note
3HAC059896-009,
3HAC063898-009,
3HAC072448-009
Note/Illustration
Location of wrist strap button:
xx1800000683
Removing the controller covers on page 222
Product manual - OmniCore C30
570.
3HAC060860-001 Revision: P