ABB OmniCore C30 Product Manual page 79

1
2
Hanging the front part of the FlexPendant holder with screws (Vertically)
Use this procedure to hang the front part of the FlexPendant holder to the desired
place.
1
2
3
Product manual - OmniCore C30
3HAC060860-001 Revision: P
Action
Hang the FlexPendant holder to the
bracket according to the screws on the
bracket.
Hang the holder with the bracket to the
desired place.
Action
Remove the four screws.
Separate the rear part from the FlexPend-
ant holder.
Clean the surface and make sure it is dry.
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.6 Mounting the FlexPendant holder
Note/illustration
xx2000002354
xx2000002355
Note/illustration
xx2000002356
Continues on next page
Continued
79