Installing The Scalable I/O Devices - ABB OmniCore C30 Product Manual

3.7.2 Installing the scalable I/O devices

Location
The location of the base unit used as a scalable I/O internal unit is shown in the
following illustration.
When no base unit is installed, the location for the unit is covered by a slot cover
that must be removed before installation.
xx1800000032
The base unit can also be used as a scalable I/O external unit, with or without
add-on devices.
For more information about installing, configuring, and using the scalable I/O units,
see Application manual - Scalable I/O.
Required parts
Part
DSQC1030 Digital slot cover
Scalable I/O Digital base [3032-1]
Connectors digital base/add on
Harness Ethernet with Mini-IO
Required tools and equipment
Equipment
Standard toolkit
ESD protective wrist band
Required documents
Document
Circuit diagram - OmniCore C30,
Circuit diagram - OmniCore C30
for IRB 14050, Circuit dia-
gram - OmniCore C30 for CRB
15000
Application manual - Scalable I/O
Product manual - OmniCore C30
3HAC060860-001 Revision: P
X1
X4
X2
X3
X45
Q0
X0
X17
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.2 Installing the scalable I/O devices
X14 X15
X20
X19
ETHERNET SWITCH
I/O
ABB Ability™
X18 WAN LAN MGMT
Article number Note
3HAC065147-001 DSQC1030
3HAC058663-001
3HAC060919-001
3HAC064092-001 Harness K5.1.X5 - Adapter
Article number Note
- Content is defined in section
Standard toolkit for controller on
page
-
Article number Note
3HAC059896-009,
3HAC063898-009,
3HAC072448-009
3HAC070208-001
570.
Continues on next page
141