ABB OmniCore C30 Product Manual page 153

3.7.4 Installing the power supply optional device and the harness 24 V extension
Required spare parts
Spare part
Optional power supply
Harness DeviceNet/Harness 24V
ext. cover plate
Harness 24V_Process output
Connector Single-row female
Required tools and equipment
Equipment
Standard toolkit
ESD protective wrist band
Required documents
Document
Circuit diagram - OmniCore C30,
Circuit diagram - OmniCore C30
for IRB 14050, Circuit dia-
gram - OmniCore C30 for CRB
15000
Installing the optional power supply and the harness 24 V extension
Preparations
1
Product manual - OmniCore C30
3HAC060860-001 Revision: P
Note
The optional power supply and the harness 24 V extension must be installed at
the same time.
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C30 via myABB Business Portal,
www.abb.com/myABB.
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
Article number Note
3HAC071301-001 DSQC3035
3HAC063601-001
3HAC060965-001 DSQC 688
3HAC064743-001 Mating connector for IP20 power
outlet connector
Article number Note
- Content is defined in section
Standard toolkit for controller on
page
-
Article number Note
3HAC059896-009,
3HAC063898-009,
3HAC072448-009
Note/Illustration
Continued
570.
Continues on next page
153