ABB OmniCore C30 Product Manual page 12

Overview of this manual
Continued
Revision
M
N
P
12
Description
Published in release 21D. The following updates are made in this revision:
• Added information about safety digital base device.
• Added information about main computer fan.
• Added supported robot IRB 1200, 910INV and 920.
• Updated structure in section
• Updated structure in section
• Updated the section
• Added connector type information of CFI harness in section
ness CFI connection (option) on page
• Removed fieldbus adapter slave throughout the manual.
Published in release 22A. The following updates are made in this revision:
• Added information on decoupling ES output and ES input, see
scriptions for connectors on page
functions on page
• Part numbers for mating connectors corrected in
change proxy mating connectors on page
• Information about I/O Network added in section
page 111.
Published in release 22B. The following updates are made in this revision:
• Minor corrections in section
• Added note that the content of the section ABB Ability is only avail-
able in English (also in translated manuals).
• Added related information that the approval code CMIIT ID is finally
displayed on the nameplate of the product in section
the connected services gateway on page
• Updated manipulator cables in section
page 597.
• Information added in section
that two industrial network masters can be run in parallel on the
OmniCore controller.
© Copyright 2019-2022 ABB. All rights reserved.
Descriptions for connectors on page
Controller parts on page
Ethernet networks on OmniCore on page
121.
112, and Configuring robot stopping
126.
112.
Descriptions for connectors on page
538.
Manipulator cables on
Available industrial networks on page 133
Product manual - OmniCore C30
3HAC060860-001 Revision: P
112.
576.
104.
X2 har-
De-
Robot signal ex-
Firewall settings on
112.
Troubleshooting