ABB OmniCore C30 Product Manual page 94

3 Installation and commissioning
3.5.4 Fitting the connector
Continued
2
3
4
5
6
Continues on next page
94
Action
Connect the wires according to the illus-
tration. Use a four-indent crimp tool to
make the connection tight.
Fit the cable through the gland and the
crown clamp of the connector.
Strip the outer cover of the cable about
27 mm.
Strip the shielding copper wires of the
cable about 27 mm if needed.
Strip the insulation of the wires about 7
mm.
© Copyright 2019-2022 ABB. All rights reserved.
Note/illustration
D
A
C
B
xx1700000741
For single phase:
A X0.1 Line (L1)
B X0.2 Neutral (N) or Live (L2)
C Not used
D X0.PE Protective Earth (PE), ground-
ing
xx1900000045
xx1900000046
xx1900000047
xx1900000048
Product manual - OmniCore C30
3HAC060860-001 Revision: P