ABB OmniCore C30 Product Manual page 435

Equipment
ESD protective wrist band
Required documents
Document
Circuit diagram - OmniCore C30,
Circuit diagram - OmniCore C30
for IRB 14050, Circuit dia-
gram - OmniCore C30 for CRB
15000
Removing the incoming mains connector
Preparations
1
2
3
Removing the axis computer from the frame
1
Product manual - OmniCore C30
3HAC060860-001 Revision: P
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 47.
Remove the top and left covers and the
front panel of the controller.
Action
Disconnect:
• A1.X3 - K6.X11
• K6.X2 - A2.X9
• K6.X1 - K2.X3.
© Copyright 2019-2022 ABB. All rights reserved.
5.3.3 Replacing the incoming mains connector
Article number Note
-
Article number Note
3HAC059896-009,
3HAC063898-009,
3HAC072448-009
Note/Illustration
Location of wrist strap button:
xx1800000683
Removing the controller covers on page
Note/Illustration
5 Repair
Continued
222.
Continues on next page
435