ABB OmniCore C30 Product Manual page 175

Removing the robot signal exchange proxy
1
2
3
Product manual - OmniCore C30
3HAC060860-001 Revision: P
3.7.5 Installing the fieldbus master and the DeviceNet harness
Action
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
Pull the cable ties out from the locking
holes.
Remove the screws and lift out the robot
signal exchange proxy.
Note
Avoid colliding with the frame of the
controller.
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
Note/Illustration
Location of wrist strap button:
xx2000000532
xx1800000488
Continues on next page
Continued
175