About The Automatic Mode - ABB OmniCore C30 Product Manual

1.4.2 About the automatic mode

The automatic mode
Automatic mode is an operating mode in which the robot operates in accordance
with the task program(s).
Tasks normally performed in automatic mode
The following tasks are typically performed in automatic mode:
Safeguard mechanisms
Product manual - OmniCore C30
3HAC060860-001 Revision: P
• Start and stop of program execution.
• Increase or decrease the speed in between zero and programmed speed.
• Restore backups. Only possible when robot is at stop.
• Load, start, stop, and modify RAPID programs through remote clients.
• Protective stop through
- Automatic Stop, AS (See actual configuration for the protective stop
function. The protective stop function can be be configured to either
Automatic Stop, AS, or General Stop, GS.)
Note
Prior to allowing the robot to operate in automatic mode, ensure that any
suspended safeguards, are returned to full functionality.
© Copyright 2019-2022 ABB. All rights reserved.
1 Safety
1.4.2 About the automatic mode
29