Replacing The Incoming Mains Connector - ABB OmniCore C30 Product Manual

5 Repair

5.3.3 Replacing the incoming mains connector

5.3.3 Replacing the incoming mains connector
Location
The illustration shows the location of the incoming mains connector in the controller.
xx1800000040
Required spare parts
Spare part
Harness Power input single phase
Connector AC power inlet, M22
PLUG
Required tools and equipment
Equipment
Standard toolkit
Continues on next page
434
Note
To confirm whether this unit is available in your controller, see chapter
of the controller on page
If this unit is not available in your controller, ignore the related procedure to this
unit when you do any maintenance or repair work.
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C30 via myABB Business Portal,
www.abb.com/myABB.
© Copyright 2019-2022 ABB. All rights reserved.
38.
Article number
3HAC058827-001
3HAC064793-001
Article number
-
Overview
Note
Harness-Mains connection
Mating connector for Power inlet
Note
Content is defined in section
Standard toolkit for controller on
page 570.
Product manual - OmniCore C30
3HAC060860-001 Revision: P