ABB OmniCore C30 Product Manual page 105

Connectors
Connectors on C line/ V line controllers
1
xx2100002082
1
2
3
4
5
6
7
Product manual - OmniCore C30
3HAC060860-001 Revision: P
ETHERNET SWITCH
I/O
2
ABB Ability™
3
C line controller label
I/O
ETHERNET SWITCH
ABB Ability™
WAN
LAN
MGMT (Management)
HMI (FlexPendant)
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.7 Ethernet networks on OmniCore
WAN LAN MGMT HMI
4 5 6
7
Description
ABB Scalable I/O. Connected to the control-
ler's Private Network. Intended for chaining
more ABB Scalable I/O units.
Connected to the controller's Private Net-
work. Intended for connecting ABB Scalable
I/O units and network based process equip-
ment local to the controller.
Intended for connecting the controller to in-
ternet/ABB Ability™.
Connected to the controller's Public Network.
Intended for connecting the robot controller
to a factory wide industrial network.
Connected to the controller's I/O Network.
Intended for connecting the robot controller
to a factory wide industrial network isolated
from WAN.
Connected to the controller's Private Net-
work. The MGMT port shall be used by ser-
vice personnel in close proximity to the con-
troller, with a single client connected to the
controller.
Note
The management port shall never be used
for more than one client at a time. ABB Robot-
ics assumes no responsibility for any er-
rors/hazards that may appear when more
than one client is used.
Specific connector for connecting the Flex-
Pendant.
Continued
Continues on next page
105