ABB OmniCore C30 Product Manual page 436

5 Repair
5.3.3 Replacing the incoming mains connector
Continued
2
3
Removing the incoming mains connector
1
2
3
4
Refitting the incoming mains connector
Refitting the incoming mains connector
1
Continues on next page
436
Action
Remove the screws on the bracket.
Loosen the screw and disconnect:
• SMB - K6.X4, K6.X5
Action
Disconnect:
• Q0 - A1.X1.
• Two ground cables which con-
nects to the left cabinet frame.
Remove the attachment screws on the
front panel.
Push the incoming mains connector into
the cabinet.
Take the incoming mains connector out
from the left side.
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
© Copyright 2019-2022 ABB. All rights reserved.
Note/Illustration
xx1900001200
Note/Illustration
xx1800000733
Note/Illustration
Product manual - OmniCore C30
3HAC060860-001 Revision: P