ABB OmniCore C30 Product Manual page 413

2
3
Removing the manipulator signal connector
1
2
3
Refitting the manipulator signal connector
Refitting the manipulator signal connector
1
Product manual - OmniCore C30
3HAC060860-001 Revision: P
5.3.1 Replacing the manipulator signal connector (SMB)
Action
Remove the screws on the bracket.
Loosen the screw and disconnect:
• K6.X4, K6.X5 - SMB.
Action
Remove the attachment screws on the
cover.
Push the manipulator signal connector
into the cabinet.
Take the manipulator signal connector
out from the upper side.
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
© Copyright 2019-2022 ABB. All rights reserved.
Note/Illustration
xx1800000472
Note/Illustration
xx1800000727
Note/Illustration
Continues on next page
5 Repair
Continued
413