Honda Accord 2008 Manual page 141

07/11/02 09:22:26 61TA0000_060_0018
Cylinder Head
Cam Chain Installation (cont'd)
15. Apply liquid gasket, P/N 08717-0004, 08718-0001,
08718-0003, or 08718-0009, evenly to the engine
block mating surface of the chain case. Install the
component within 5 minutes of applying the liquid
gasket.
NOTE:
• If you apply liquid gasket P/N 08718-0012, the
component must be installed within 4 minutes.
• If too much time has passed after applying the
liquid gasket, remove the old liquid gasket and
residue, then reapply new liquid gasket.
＊１１
16. Apply liquid gasket to the engine block upper
surface contact areas (A) on the chain case and
lower block upper surface contact areas (B) on the
chain case.
17. Apply liquid gasket, P/N 08717-0004, 08718-0001,
08718-0003, or 08718-0009, evenly to the oil pan
mating surface of the chain case. Install the
component within 5 minutes of applying the liquid
gasket.
NOTE:
• If you apply liquid gasket P/N 08718-0012, the
component must be installed within 4 minutes.
• If too much time has passed after applying the
liquid gasket, remove the old liquid gasket and
residue, then reapply new liquid gasket.
＊１２
6-18
A
B
Apply liquid gasket
along the broken line.
Apply liquid gasket
along the broken line.
18. Install the spacer (A), then install the new O-ring (B)
on the chain case. Set the edge of the chain case (C)
to the edge of the oil pan (D), then install the chain
case on the engine block (E). Wipe off the excess
liquid gasket on the oil pan and chain case mating
area.
NOTE:
• When installing the chain case, do not slide the
bottom surface onto the oil pan mounting surface.
• Wait at least 30 minutes before filling the engine
with oil.
• Do not run the engine for at least 3 hours after
installing the chain case.
A
B
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
A
10 x 1.25 mm
44 N·m
(4.5 kgf·m,
33 lbf·ft)
B
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
E
C
D
＊１３
＊１４