Define Blank (Workpiece) - Siemens SINUMERIK 840D sl Programming Manual

Work preparation
3.23 Additional functions
Note
Alarm texts must be configured in the user interface.
Note
If an alarm is to be output in the language active at the user interface, then the user requires
information about the language that is currently set at the HMI. This information can be
requested in the part program and in synchronized actions via the system
variable $AN_LANGUAGE_ON_HMI (Page 1303).
Example
Program code
...
N100 SETAL (65000)
...
Further information
Alarm response and acknowledgment
User cycle alarms are assigned to number ranges that differ with regard to alarm response and
acknowledgment:
Number range
65000 - 65499
65500 - 65999
66000 - 66999
67000 - 67999
68000 - 68999
69000 - 69999
3.23.6

Define blank (WORKPIECE)

The controller must know the shape and size of a blank to be able to display it in the graphical
simulation. The user therefore has the capability of defining blanks via the user interface or
directly in the NC program. The definitions of blanks are retained beyond a (program end/
channel/BAG) reset. They are automatically deleted the next time that the control system
powers up.
1002
Comment
;Set alarm no. 65000
Alarm response
Display, NC Start disable
Display, NC Start disable (not for ASUBs for set MD20194)
Display, NC Start disable, motion standstill after executing
the pre-decoded blocks
Display
Display, NC Start disable, immediate interpolator stop
Display, NC Start disable, stop at next block end
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Alarm acknowl‐
edgment
Reset
Reset
Reset
Cancel
Reset
Reset
NC programming