Disable; Hold-Time - Dell C9000 Series Reference Manual

disable

Disable a VRRP group.
C9000 Series
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage Information To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-
address command and enter no disable.
Related virtual-address
Commands

hold-time

Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization
of the VRRP MASTER, the new switch can stabilize its routing tables.
C9000 Series
Syntax
hold-time {seconds | centisecs centisecs}
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— specifies the IP address of the virtual router.
Virtual Router Redundancy Protocol (VRRP) 2241