Power Over Ethernet Commands; Power Inline; Power Inline Powered-Device - Dell PowerConnect 3524 Cli Reference Manual

Power over Ethernet Commands

power inline

The port inline Interface Configuration (Ethernet) mode command configures the administrative
mode of inline power on an interface.
Syntax
• power inline {auto | never}
• auto — Enables the device discovery protocol and, if found, supplies power to the device.
• never — Disables the device discovery protocol and stops supplying power to the device.
Default Configuration
The device discovery protocol is enabled.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example enables powered device discovery protocol on port 1/e1, so that power will be
supplied to a discovered device.
Console(config)# interface ethernet 1/e1
Console(config-if)# power inline auto

power inline powered-device

The power inline powered-device Interface Configuration (Ethernet) mode command adds a
comment or description of the powered device type to enable the user to remember what is attached
to the interface. Use the no form of this command to remove the description.
Power over Ethernet Commands
281