Vrrp Delay Minimum - Dell C9000 Series Reference Manual

vrrp delay minimum

Set the delay time for VRRP initialization after an interface comes up.
C9000 Series
Syntax
vrrp delay minimum seconds
Parameters
seconds
Defaults 0
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.8.0
Usage Information This command applies to a single interface. When used with the vrrp delay reload
CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is
600 and the vrrp delay minimum is 300:
Related Command vrrp delay reload
Enter the number of seconds for the delay for VRRP initialization
after an interface becomes operational. The range is from 0 to
900 (0 indicates no delay).
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP
on all interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
— sets the delay time for VRRP initialization after a system reboot.
Virtual Router Redundancy Protocol (VRRP) 2252