Configuring The Connection Ends - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
2. Navigate to tunnel » ipsec » connection » {connection} » esp » algorithm, where {connection} is the
name of the connection. The Algorithm table appears.
1
Figure 736: Algorithm Table
1. Add Button
3. Click Delete next to the chosen algorithm.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
4.
to proceed.
Click Exit Transaction or continue making changes.
5.
Section 5.28.9

Configuring the Connection Ends

Each IPsec tunnel has two ends: the local router and the remote router. These are otherwise referred to as the
left and right connections, respectively. Both ends can have the same configuration or a unique configuration.
NOTE
The configuration forms for the left and right connection ends are the same.
To configure a connection end for an IPsec tunnel, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to tunnel » ipsec » connection » {connection} » {end}, where {connection} is the name of the
connection and {end} is the either the left (local router) or right (remote router) connection end. The Public IP
Address, System Public Key, System Identifier, Nexthop to Other System and Left/Right forms appear.
Configuring the Connection Ends
2
2. Edit Button 3. Delete Button
3
Chapter 5
Setup and Configuration
631