Deleting A Static Vlan - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Parameter
VLAN ID
Click Add to create the new static VLAN. The Static VLAN Table form appears.
4.
Figure 844: Static VLAN Table Form
1. IGMP Snooping Check Box
5. Configure the following parameter(s) as required:
NOTE
If IGMP Snooping is not enabled for the VLAN, both IGMP messages and multicast streams
will be forwarded directly to all members of the VLAN. If any one member of the VLAN joins a
multicast group, then all members of the VLAN will receive the multicast traffic.
Parameter
IGMP Snooping
MSTI
6. If needed, configure a forbidden ports list. For more information, refer to
Forbidden Port".
7. Configure the VLAN. For more information, refer to
Ports".
8. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
9. Click Exit Transaction or continue making changes.
Section 5.35.4.3

Deleting a Static VLAN

To delete a static VLAN for either a routable Ethernet port or virtual switch, do the following:
Deleting a Static VLAN
Description
<int, 1 \.\. 15>;;The VLAN identifier is used to identify the VLAN in tagged Ethernet
frames according to IEEE 802.1Q.
1
2
2. MSTI Box
Description
Enables or disables IGMP Snooping on the VLAN.
Synopsis: cst,
Default: cst
Only valid for Multiple Spanning Tree Protocol (MSTP) and has no effect, if MSTP is not
used. The parameter specifies the Multiple Spanning Tree Instance (MSTI) the VLAN
should be mapped to.
Section 5.35.5.2, "Adding a
Section 5.35.2, "Configuring VLANs for Switch Ethernet
Chapter 5
Setup and Configuration
735