Managing Static Label Binding; Viewing The Status Of Static Label Binding - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
Enabled
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.39.5

Managing Static Label Binding

The following sections describe how to configure and manage static label binding for MPLS:
• Section 5.39.5.1, "Viewing the Status of Static Label Binding"
• Section 5.39.5.2, "Viewing a List of Static Labels"
• Section 5.39.5.3, "Adding a Static Label"
• Section 5.39.5.4, "Deleting a Static Label"
Section 5.39.5.1

Viewing the Status of Static Label Binding

To view the status of all configured static label binding, navigate to mpls » status » static-binding. If static label
binding has been configured, the Static MPLS IP Address Bindings table appears.
Figure 929: Static MPLS IP Address Bindings Table
This table provides the following information:
Parameter
IP Address
In Label
Out Label
Next Hop
If no static label binding has been configured, configure binding as needed. For more information about
configuring static-binding, refer to
806
Description
Default: false
A boolean flag to indicate Multiprotocol Label Switching (MPLS) forwarding of IP packets
is enabled on this interface.
Description
The destination address prefix.
The incoming (local) label.
The outgoing (remote) label.
The destination next hop router.
Section 5.39.5.3, "Adding a Static Label".
Managing Static Label Binding
RUGGEDCOM ROX II
User Guide