RUGGEDCOM ROX II
User Guide
Parameter
Prefix List
5.
On the Match form, configure the following parameters as required:
Parameter
Interface Name
6.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7.
Click Exit Transaction or continue making changes.
Section 5.21.7
Managing Incoming Route Filters
Incoming route advertisements can be filtered by assigning one or route map filters. This can be useful for
excluding specific OSPF routes from the routing table.
NOTE
For more information about route map filters, refer to
The following sections describe how to configure and manage incoming route filters:
•
Section 5.21.7.1, "Viewing List of Incoming Route Filters"
•
Section 5.21.7.2, "Adding an Incoming Route Filter"
•
Section 5.21.7.3, "Deleting an Incoming Route Filter"
Section 5.21.7.1
Viewing List of Incoming Route Filters
To view a list of route filters configured for incoming advertised routes, navigate to routing » dynamic » ospf »
incoming-route-filter. If route filters have been configured, the Incoming Route Filter table appears.
Figure 609: Incoming Route Filter Table
If noroute filters have been configured, add filters as needed. For more information, refer to
"Adding an Incoming Route
Managing Incoming Route Filters
Description
The prefix list name.
Description
The interface name.
Filter".
Section 5.21.6, "Managing Route
Chapter 5
Setup and Configuration
Maps".
Section 5.21.7.2,
527