Viewing The Status Of Dynamic Rip Routes - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
Timeout Timer
Garbage Collection Timer
In the RIP Configuration form, configure the following parameters:
4.
Parameter
Enable RIP
Default Information Originate
Default Metric
Distance Default
Version
5. Configure prefix lists. For more information, refer to
6. Configure a network. For more information, refer to
7. Configure the prefix list distribution. For more information, refer to
Distribution Path".
8. Configure key chains. For more information, refer to
9. Configure redistribution metrics. For more information, refer to
Metric".
10. Configure interfaces. For more information, refer to
11. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
12. Click Exit Transaction or continue making changes.
Section 5.20.2

Viewing the Status of Dynamic RIP Routes

To view the status of the dynamic RIP routes configured on the device, navigate to routing » status » rip »
route. If RIP routes have been configured, the Route table appears.
478
Description
The routing table update timer (in seconds).
Default: 180
The routing information timeout timer (in seconds).
Default: 120
The garbage collection timer (in seconds).
Description
Enables the RIP dynamic routing protocol.
The route element makes a static route only inside RIP. This element should be used
only by advanced users who are particularly knowledgeable about the RIP protocol. In
most cases, we recommend creating a static route and redistributing it in RIP using the
redistribute element with static type.
Default: 1
Sets the default metric. With the exception of connected route types, the default metric
is advertised when a metric has not been configured for a redistributed route. For
connected route types, the default metric is 1 despite the value of this parameter.
Sets the default RIP distance.
Set the RIP version to accept for reads and send. The version can be either 1 or 2.
Disabling RIPv1 by specifying version 2 is STRONGLY encouraged.
Section 5.20.3.3, "Adding a Prefix
Section 5.20.4.1, "Configuring a
Section 5.20.9.3, "Adding a Key
Section 5.20.11.2, "Configuring a Routing
List".
Network".
Section 5.20.8.2, "Adding a Prefix List
Chain".
Section 5.20.10.2, "Adding a Redistribution
Viewing the Status of Dynamic RIP Routes
RUGGEDCOM ROX II
User Guide
Interface".