Deleting A Prepended Autonomous System Path Filter - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Figure 503: Key Settings Form
1. AS Number Box
4. Configure the following parameter(s) as required:
Parameter
AS Number
5. Click Add to add the filter.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
Click Exit Transaction or continue making changes.
7.
Section 5.19.4.5

Deleting a Prepended Autonomous System Path Filter

To delete a prepended autonomous system path filter from a BGP route map entry, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » dynamic » bgp » filter » route-map » {name} » entry » {number} » set » as-path »
2.
prepend, where {name} is the name of the route map and {number} is the entry number. The AS Path to
Prepend table appears.
1
Figure 504: AS Path to Prepend Table
1. Add Button
Deleting a Prepended Autonomous System Path Filter
1
2. Add Button
Description
AS number.
2 3
2. Edit Button 3. Delete Button
Chapter 5
Setup and Configuration
2
451