Siemens RX1500 User Manual page 515

RUGGEDCOM ROX II
User Guide
1. Change the mode to Edit Private or Edit Exclusive.
2. Depending on the dynamic routing protocol being configured, navigate to routing » dynamic » rip » filter »
{name} » entry, where {name} is the name of the prefix list.
Click <Add entry>. The Key Settings form appears.
3.
Figure 548: Key Settings Form
1. Sequence Number Box
4. Configure the following parameter(s) as required:
Parameter
Sequence Number
5. Click Add to create the new entry. The Prefix List Entry form appears.
Figure 549: Prefix List Entry Form
1. ActionList 2. Network Box
6. Configure the following parameter(s) as required:
Adding a Prefix Entry
1
2. Add Button
Description
The sequence number of the entry.
1
2
3
4
3. Maximum Prefix to Mask for Subnet 4. Minimum Prefix to Mask for Subnet
Chapter 5
Setup and Configuration
2
483