Configuring Qos Marking - Siemens RX1500 User Manual

Ruggedcom rox ii series
Hide thumbs Also See for RX1500:
Table of Contents

Advertisement

Chapter 5
Setup and Configuration
Parameter
Source Ports
test
length
tos
description
NOTE
Only one QoS mark is allowed for each traffic control rule.
6.
Configure the rules for a QoS mark. For more information, refer to
Marking".
7.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8.
Click Exit Transaction or continue making changes.
Section 5.37.6.3

Configuring QoS Marking

Quality of Service (QoS) marking applies a mark to important data packets that should receive preferential
treatment as they travel through the network. Only one QoS mark is allowed for each traffic control rule. Options
include:
• Set: Determines whether the packet or the connection is assigned the QoS mark.
• Modify: Changes the QoS mark value using an AND or OR argument.
• Save/Restore: Replaces the connection's QoS mark value with an assigned value.
• Continue: If the packet matches, no more traffic control rules are checked and the packet is automatically
forwarded to the specified chain.
• DSCP Marking: Determines whether the packet is assign the DSCP mark.
To configure the QoS mark for a traffic control rule, do the following:
776
Description
(Optional) A comma- separated list of port names, port numbers or port ranges.
(Optional) Defines a test on the existing packet or connection mark.
The default is a packet mark. For testing a connection mark, add ':C' at the end of the
test value. Ex.:
Test if the packet mark is not zero:
!0
Test if the connection mark is not zero:
!0:C
(Optional) Matches the length of a packet against a specific value or range of values...
Greater than and lesser than, as well as ranges are supported in the form of min:max.
Ex.: Equal to 64 64 Greater or equal to 65 65: Lesser or equal to 65 :65 In-between 64
and 768 64:768
Synopsis: minimize-delay, maximize-throughput, maximize-reliability, minimize-cost,
normal-service
(Optional) Type of Service .
A pre-defined ToS value or a numerical value. The
numerical value is hexadecimal. Ex.: 0x38
A description for this configuration item.
Section 5.37.6.3, "Configuring QoS
Configuring QoS Marking
RUGGEDCOM ROX II
User Guide

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx1501Rx1510Rx1511Rx1512

Table of Contents