Viewing A List Of Dhcp Client Ports; Adding Dhcp Client Ports - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.14.2

Viewing a List of DHCP Client Ports

To view a list of DHCP relay agent client ports, navigate to switch » dhcp-relay-agent » dhcp-client-ports. If
client ports have been configured, the DHCP Relay Agent Client Ports table appears.
Figure 325: DHCP Relay Agent Client Ports Table
If no client ports have been configured, add client ports as needed. For more information, refer to
"Adding DHCP Client
Section 5.14.3

Adding DHCP Client Ports

To add a client port for the DHCP relay agent, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to switch » dhcp-relay-agent » dhcp-client-ports and click <Add dhcp-client-ports>. The Key
Settings form appears.
Figure 326: Key Settings Form
1. Slot List 2. Add Button
3. Configure the following parameter(s) as required:
Parameter
Slot
Port
4. Click Add to add the client port.
Viewing a List of DHCP Client Ports
Ports".
1
Description
Synopsis: sm, lm1, lm2, lm3, lm4, lm5, lm6
The name of the module location provided on the silkscreen across the top of the
device.
The selected ports on the module installed in the indicated slot.
Chapter 5
Setup and Configuration
Section 5.14.3,
2
309