Configuring The Device; Inserting/Removing The Clp - Siemens SIMATIC NET RUGGEDCOM RST916P Equipment Manual

Device Management
3.2 Configuring the Device
device's IP address. The factory default IP address for the RUGGEDCOM RST916P is
https://192.168.0.1.
For more information about available ports, refer to "Communication
Ports" (Page 25).
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RST916P interface.
For more information about configuring the device, refer to the "RUGGEDCOM ROS
Configuration Manual" associated with the installed software release.
3.3

Inserting/Removing the CLP

The following describes how to insert and remove the Configuration and Licensing
Plug (CLP).
Security hazard – risk of unauthorized access and/or exploitation
Make sure to remove the CLP before decommissioning the device or sending the
device to a third-party.
Mechanical/electrical hazard – risk of damage to the CLP
•
•
•
Contamination hazard – risk of equipment damage
A blank insert is included with the device. Use the blank insert when the CLP is
removed to prevent the ingress of water, dirts and other debris.
22
NOTICE
NOTICE
Do not expose the CLP to extreme temperatures or humidity
Do not expose the CLP to large magnetic or static electric fields
Do not bend or drop the CLP
NOTICE
RUGGEDCOM RST916P
Equipment Manual, 11/2023, C79000-G8976-1489-06