Siemens RX1500 User Manual page 698

Chapter 5
Setup and Configuration
Figure 786: Generic Routing Encapsulation Interfaces Form
1. Local Address Box
5. Configure the following parameter(s) as required:
Parameter
local-ip
remote-ip
remote-net
mtu
multicast
cost
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
Click Exit Transaction or continue making changes.
7.
666
1
2
3
4
5
6
2. Remote Address Box 3. Remote Subnet Box
Description
The IP address of the local end of the tunnel.
The IP address of the remote end of the tunnel.
The target network of the remote end of the tunnel (xxx.xxx.xxx.xxx/xx).
Default: 1476
The MTU of the GRE interface.
Enables multicast traffic on the tunnel interface.
Default: 1
The routing cost associated with networking routing that directs traffic through the
tunnel.
4. MTU Box 5. Multicast Check Box
RUGGEDCOM ROX II
User Guide
6. Cost Box
Adding a GRE Tunnel