Configuring The Destination Zone; Deleting A Policy - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.17.11.4

Configuring the Destination Zone

To configure the destination zone for a firewall policy, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to security » firewall » fwconfig » {firewall} » fwpolicy{policy} » destintion-zone, where
2.
{firewall} is the name of the firewall and {policy} is the name of the policy. The Destination Zone form
appears.
Figure 428: Destination Zone Form
1. Pre-Defined Zone List
3. Configure the following parameter(s) as required:
Parameter
predefined-zone
all
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.17.11.5

Deleting a Policy

To delete a policy, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to security » firewall » fwconfig » {firewall} » fwpolicy, where {firewall} is the name of the
firewall. The Main Policy Settings table appears.
Configuring the Destination Zone
2. All Check Box
Description
Chapter 5
Setup and Configuration
391