Managing Data Links For Frame Relay Connections; Viewing A List Of Data Links - Siemens RX1500 User Manual

Ruggedcom rox ii series
Hide thumbs Also See for RX1500:
Table of Contents

Advertisement

Chapter 3
Device Management
Parameter
n392
n393
5.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6.
Click Exit Transaction or continue making changes.
Section 3.24.14

Managing Data Links for Frame Relay Connections

Before data can be forwarded over a Frame Relay connection to a remote destination, links to link-local virtual
circuits must be configured.
The following sections describe how to configure and manage data links for a Frame Relay connection:
Section 3.24.14.1, "Viewing a List of Data Links"
Section 3.24.14.2, "Adding a Data Link"
Section 3.24.14.3, "Deleting a Data Link"
Section 3.24.14.1

Viewing a List of Data Links

To view a list of data links configured for a frame relay connection, navigate to interface » wan » {interface} »
{protocol} » channel » {number} » connection » framerelay » dlci, where {interface} is the WAN interface,
{parameter} is either T1 or E1, and {number} is the channel number. If data links have been configured, the DLCI
table appears.
Figure 179: DLCI Table
If no data links have been configured, add data links as needed. For more information, refer to
"Adding a Data
Link".
170
Description
Defines the frequency of transmission of full status enquiry messages. Valid for CPE.
Default: 4
The number of error events (enumerated by n393) for which the channel is declared
inactive; valid for either cpe or Switch.
Default: 4
The number of error events on the frame relay channel; valid for either
cpe or switch.
Managing Data Links for Frame Relay Connections
RUGGEDCOM ROX II
User Guide
Section 3.24.14.2,

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx1501Rx1510Rx1511Rx1512

Table of Contents