Viewing A List Of Autonomous System Path Entries; Adding An Autonomous System Path Filter - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 514: Autonomous System Path Filter Table
If no filters have been configured, add filters as needed. For more information, refer to
an Autonomous System Path
Section 5.19.6.2

Viewing a List of Autonomous System Path Entries

To view a list of entries for an autonomous system path filter, navigate to routing » dynamic » bgp » filter » as-
path » {name} » entry, where {name} is the name of the autonomous system path filter. If entries have been
configured, the Entry table appears.
Figure 515: Entry Table
If no filters have been configured, add filters as needed. For more information, refer to
an Autonomous System Path
Section 5.19.6.3

Adding an Autonomous System Path Filter

To add an autonomous system path filter for dynamic BGP routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » dynamic » bgp » filter » as-path and click <Add as-path>. The Key Settings form
2.
appears.
458
Filter".
Filter".
Section 5.19.6.3, "Adding
Section 5.19.6.3, "Adding
Viewing a List of Autonomous System Path Entries
RUGGEDCOM ROX II
User Guide