Configuring A Static Rp Address - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
NOTE
Uncheck the Passive Enabled check box to activate PIM-SM on the interface, or check the
Passive Enabled check box to disable PIM-SM on the interface.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
5.
to proceed.
Click Exit Transaction or continue making changes.
6.
Section 5.24.5

Configuring a Static RP Address

To configure a Static RP address, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to routing » multicast » dynamic » pim-sm » rp-address and click <Add dest-address>. The
Key Settings form appears.
Figure 650: RP Address Form
1. Address Box
3. Configure the following parameters as required:
Parameter
Address
Group
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
558
1
2
2. Group Box 3. Add Button
Description
Static RP (Rendezvous Point) address.
The multicast group the RP handles.
RUGGEDCOM ROX II
User Guide
3
Configuring a Static RP Address