Adding A Remote Daemon - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 765: Remote Daemon of Goose Tunnel Table
If no remote daemons have been configured, add daemons as needed. For more information, refer to
Section 5.29.6.2, "Adding a Remote
Section 5.29.6.2

Adding a Remote Daemon

To configure a remote daemon for a GOOSE tunnel, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to tunnel » l2tunneld » goose » {tunnel} » remote-daemon, where {tunnel} is the name of the
2.
GOOSE tunnel.
Click <Add remote-daemon>. The Key Settings form appears.
3.
Figure 766: Key Settings Form
1. IP Address Box
4. Configure the following parameter(s) as required:
Parameter
ip-address
5. Click Add to create the daemon.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
Click Exit Transaction or continue making changes.
7.
652
Daemon".
1
2. Add Button
Description
The IP address of the remote Layer 2 protocol server.
RUGGEDCOM ROX II
User Guide
2
Adding a Remote Daemon