Deleting A Device Address Table; Managing Remote Hosts - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Parameter
remote-ip
remote-device
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 3.21.10.3

Deleting a Device Address Table

To delete a Device Address table, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » serial » {slot/port} » protocols » dnp » setdnp » device-table, where {slot/port}
is the slot name and port number of the serial port. The DNP Device Address Table Configuration table
appears.
1
Figure 131: DNP Device Address Table Configuration Table
1. Add Button
Click Delete next to the chosen Device Address table.
3.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 3.21.11

Managing Remote Hosts

Remote hosts are required when the UDP transport connection protocol is selected for the raw socket protocol.
The following sections describe how to configure and manage remote hosts:
• Section 3.21.11.1, "Viewing a List of Remote Hosts"
• Section 3.21.11.2, "Adding a Remote Host"
Deleting a Device Address Table
Description
The IP address of the remote host that provides a connection to the DNP device with
the configured address. Leave this field empty to forward DNP messages that match the
configured address to the local serial port.
Enables forwarding of DNP messages that match the device address to the remote IP.
2. Edit Button 3. Delete Button
2 3
Chapter 3
Device Management
131