Configuring The Source Zone - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
. The router will still see TCP packets (i.e. retransmission packets).
If required, reboot the router to flush all existing connection streams.
Parameter
Action
Source Zone Hosts
Destination Zone Hosts
Log Level
Protocol
Source Port
Destination Port
Original Destination
description
7. Configure the source zone for the rule. For more information, refer to
Source Zone".
8. Configure the destination zone for the rule. For more information, refer to
Destination Zone".
9. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
10. Click Exit Transaction or continue making changes.
Section 5.17.14.3

Configuring the Source Zone

To configure the source zone for a firewall rule, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to security » firewall » fwconfig » {firewall} » fwrule{rule} » source-zone, where {firewall} is the
name of the firewall and {rule} is the name of the rule. The Source Zone form appears.
402
Description
Synopsis: accept, drop, reject, continue, redirect, dnat-, dnat
Default: reject
The final action to take on incoming packets matching this rule.
(Optional) Add comma-separated host IPs to a predefined source-zone.
(Optional) Add comma-separated host IPs to the destination-zone - may include :port for
DNAT or REDIRECT.
Synopsis: none, debug, info, notice, warning, error, critical, alert, emergency
Default: none
(Optional) Determines whether or not logging will take place and at which logging level.
Synopsis: tcp, udp, icmp, all
Default: all
The protocol to match for this rule.
Default: none
(Optional) The TCP/UDP port(s) the connection originated from. Default: all ports. Add a
single port or a list of comma-separated ports
Default: none
(Optional) The TCP/UDP port(s) the connection is destined for. Default: all ports. Add a
single port or a list of comma-separated ports
Synopsis: None
Default: none
(Optional) The destination IP address in the connection request as it was received by
the firewall.
(Optional) The description string for this rule.
Section 5.17.14.3, "Configuring the
Section 5.17.14.4, "Configuring the
Configuring the Source Zone
RUGGEDCOM ROX II
User Guide