Adding An Address For A Private Subnet - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 743: Private Subnet Behind System Table
If no addresses have been configured, add addresses as needed. For more information, refer to
Section 5.28.10.3, "Adding an Address for a Private
Section 5.28.10.3

Adding an Address for a Private Subnet

To add a new address for a private subnet, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to tunnel » ipsec » connection » {connection} » {end} » subnet » network, where {connection}
2.
is the name of the connection and {end} is the either the left (local router) or right (remote router) connection
end.
3. Click <Add network>. The Key Settings form appears.
Figure 744: Key Settings Form
1. Subnet Address Box
4. Configure the following parameter(s) as required:
Parameter
Subnet Address
5. Click Add to create the new address.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
636
1
2. Add Button
Description
The IP address/prefix.
Subnet".
RUGGEDCOM ROX II
2
Adding an Address for a Private Subnet
User Guide