Deleting A Serial Port Protocol - Siemens RX1500 User Manual

Chapter 3
Device Management
Parameter
pack-char
pack-timer
pack-size
turnaround
call-direction
max-connection
remote-ip
remote-port
local-ip
local-port
transport
5. If the transport connection protocol is set to UDP, configure one or more remote hosts for the port. For more
information about adding a remote host, refer to
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 3.21.9

Deleting a Serial Port Protocol

To delete a serial port protocol, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » serial » {slot/port} » protocols, where {slot/port} is the slot name and port number
of the serial port. The Serial Protocols table appears.
128
Description
Synopsis: off,
Default: off
The numeric value of the ASCII character which will force forwarding of
accumulated data to the network.
Default: 1000
The delay from the last received character until when data is forwarded.
Synopsis: max,
Default: max
The maximum number of bytes received from the serial port to be forwarded.
Default: 0
The amount of delay (if any) to insert between the transmissions of individual messages
out the serial port.
Synopsis: in, out, both
Default: out
Whether to accept an incoming connection, place an outgoing connection or do both.
Default: 1
The maximum number of incoming connections to permit when the call direction is
incoming.
The IP address used when placing an outgoing connection.
The TCP destination port used in outgoing connections.
The IP address used to establish a connection. Leaving it blank allows an incoming
connection to any interface.
The local TCP port to use to accept incoming connections.
Synopsis: tcp, udp
Default: tcp
The transport connection protocol (UDP or TCP).
Section 3.21.11.2, "Adding a Remote
RUGGEDCOM ROX II
User Guide
Host".
Deleting a Serial Port Protocol