Siemens RX1500 User Manual page 618

Chapter 5
Setup and Configuration
Figure 680: Tracker Form
1. Tracker Type List
5. Configure the following parameter(s) as required:
Parameter
Track Type
Network
Interface
Interval
Weight
Rise
Fall
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
586
1
2
3
4
5
6
7
2. Network Box 3. Interface List
Description
Synopsis: route
Default: route
The type of condition for the tracker to check.
The network to track. The tracker checks for a route to this network in the routing table.
The interface to the tracked network. The tracker rises only when the route to the
monitored network is through this interface.
The number of seconds between tracker queries.
The amount by which to increase or decrease the router's priority. When negative, the
priority decreases by this amount when the tracker falls. When positive, the priority
increases by this amount when the tracker rises. When not set, the state changes to the
fault state when the tracker falls.
The number of successful tracker queries before changing the router priority.
The number of unsuccessful tracker queries before changing the router priority.
4. Interval List 5. Weight Box
RUGGEDCOM ROX II
User Guide
6. Rise Box 7. Fall Box
Adding a VRRP Tracker