Deleting A Fixed Module Configuration; Managing Line Modules; Removing A Line Module - Siemens RX1500 User Manual

Chapter 3
Device Management
Section 3.15.3

Deleting a Fixed Module Configuration

To delete the configuration for a fixed module, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to chassis » fixed-modules. The Fixed Modules table appears.
1
Figure 81: Fixed Modules Table
1. Add Button 2. Edit Button
3. Click Delete next to the chosen fixed module configuration.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 3.16

Managing Line Modules

The following sections describe how to properly add, replace and configure line modules:
• Section 3.16.1, "Removing a Line Module"
• Section 3.16.2, "Installing a New Line Module"
• Section 3.16.3, "Viewing a List of Line Module Configurations"
• Section 3.16.4, "Configuring a Line Module"
• Section 3.16.5, "Enabling/Disabling Controlled Bypass for M12 Line Modules"
Section 3.16.1

Removing a Line Module

To remove a line module from the chassis, do the following:
1. Shut down the device. The device will shutdown for a period of time before rebooting and restarting. The
default time-out period is 300 seconds (five minutes). If more time is required to complete the procedure,
disconnect power from the device during the time-out period. For more information on how to shutdown the
device, refer to
80
3. Delete Button
Section 3.4, "Shutting Down the
2 3
Device".
RUGGEDCOM ROX II
Deleting a Fixed Module Configuration
User Guide