Chapter 3
Device Management
Section 3.21.10.2
Adding a Device Address Table
To add a Device Address table for a serial port using the DNP protocol, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2.
Navigate to interface » serial » {slot/port} » protocols » dnp » setdnp » device-table, where {slot/port} is
the slot name and port number of the serial port.
3.
Click <Add device-table>. The Key Settings form appears.
Figure 129: Key Settings Form
1. Device Address Box
4.
Configure the following parameter(s) as required:
Parameter
deviceAddress
5.
Click Add to create the Device Address table. The DNP Device Address Table Configuration form
appears.
Figure 130: DNP Device Address Table Configuration Form
1. Remote IP Box
6.
Configure the following parameter(s) as required:
130
1
2. Add Button
Description
The local or remote DNP device address. The address may be that of a DNP device
connected to a local serial port or one available via the serial port of a remote IP host.
1
2
2. Remote Device Check Box
RUGGEDCOM ROX II
User Guide
2
Adding a Device Address Table