Adding A Neighbor; Deleting A Neighbor - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.20.7.2

Adding a Neighbor

To add a neighbor for a RIP network, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to routing » dynamic » rip » network » neighbor and click <Add neighbor>. The Key Settings
form appears.
Figure 560: Key Settings Form
1. Neighbor IP Address Box
3. Configure the following parameter(s) as required:
Parameter
Neighbor IP Address
4. Click Add to add the address.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
5.
to proceed.
Click Exit Transaction or continue making changes.
6.
Section 5.20.7.3

Deleting a Neighbor

To delete a neighbor from a RIP network, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to routing » dynamic » rip » network » neighbor. The Neighbor table appears.
492
1
2. Add Button
Description
The IP address of the neighbor.
RUGGEDCOM ROX II
User Guide
2
Adding a Neighbor