Adding An Lsp Lifetime Interval - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 467: Maximum LSP Lifetime Routing Type
If no intervals have been configured, add intervals as needed. For more information, refer to
"Adding an LSP Lifetime
Section 5.18.8.2

Adding an LSP Lifetime Interval

To add an LSP lifetime interval to an IS-IS area, do the following:
IMPORTANT!
The LSP lifetime interval must be 300 seconds higher than the LSP refresh interval. For more
information about LSP refresh intervals, refer to
1. Navigate to routing » dynamic » isis » area » {name} » max-lsp-lifetime, where {name} is the unique
name for a routing process that belongs to a specific router.
2. Click <Add is-type>. The Key Settings form appears.
Figure 468: Key Settings Form
1. Routing Type List
3. Configure the following parameter(s) as required:
Parameter
Routing Type
4. Click Add to create the new limit. The Maximum LSP Lifetime Routing Type form appears.
426
Interval".
1
2. Add Button
Description
Synopsis: level-1-only, level-2-only, level-1-2
The IS type for this setting, specified as level-1-only, level-2-only or level-1-2.
Section 5.18.9, "Managing LSP Refresh
RUGGEDCOM ROX II
User Guide
Section 5.18.8.2,
Intervals".
2
Adding an LSP Lifetime Interval