Siemens RX1500 User Manual page 337

RUGGEDCOM ROX II
User Guide
Figure 322: GSM PPP Configuration Form
1. Use Peer DNS Check Box
Box 6. Failover On Demand Check Box
On the Cellular Network Configuration form, configure the following parameter(s) as required:
5.
NOTE
The Access Point Name (APN) is necessary only on GPRS networks (Edge or HSPA). It is the
name of the cellular network access point that provides a gateway to the Internet. This information
is provided by the wireless network when a data service account is registered.
NOTE
The dial string is a special command to be sent by the cellular modem to the cellular network
to establish a data connection. For example, a typical dial string for GSM/GPRS networks is
*99***1#. This command will depend on the wireless network. Contact the service provided for the
correct dial string command for data service. A regular telephone number is usually not required to
connect to a GSM/GPRS network.
Parameter
apn
dial-string
Adding a GSM Profile
1
2
3
4
5
6
7
2. Username Box 3. Password Box
7. MTU Box
Description
The name of the wireless network access point.
Default: *99***1#
4. Dial On Demand Check Box
Chapter 5
Setup and Configuration
5. Disconnect Idle Timeout
305