Deleting A Prefix Entry; Managing Networks - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.20.3.6

Deleting a Prefix Entry

To delete an entry for a dynamic RIP prefix list, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Depending on the dynamic routing protocol being configured, navigate to routing » dynamic » rip » filter »
2.
{name} » entry, where {name} is the name of the prefix list. The Prefix List Entry table appears.
1
Figure 551: Prefix List Entry Table
1. Add Button
Click Delete next to the chosen entry.
3.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.20.4

Managing Networks

As opposed to neighbors, which are specific routers with which to exchange routes, networks are groups of
routers that are either part of a specific subnet or connected to a specific network interface. They can be used at
the same time as neighbors.
NOTE
For point to point links, such as T1/E1 links, specify neighbors instead of a network. For more
information, refer to
NOTE
RIP v1 does not send subnet mask information in its updates. Any networks defined are restricted to
the classic (i.e. Class A, B and C) networks.
NOTE
If neighbors are specified but no networks are specified, the router will receive routing information from
its neighbors but will not advertise any routes to them. For more information about neighbors, refer to
Section 5.20.7, "Managing
The following sections describe how to configure and manage networks:
Deleting a Prefix Entry
2. Edit Button 3. Delete Button
Section 5.20.7.2, "Adding a
Neighbors".
2
Neighbor".
Chapter 5
Setup and Configuration
3
485