Siemens RX1500 User Manual page 675

RUGGEDCOM ROX II
User Guide
Figure 753: Static L2TPv3 Tunnels Form
1. Enabled Check Box
Field 7. Remote Port Field
6. On the Static L2TPv3 Tunnels form, configure the following parameter(s) as required:
Parameter
enabled
tunnel-id
remote-tunnel-id
local-ip
local-port
remote-ip
remote-port
7. Navigate to tunnel » l2tpv3 » static » tunnel » {tunnel name} » session and select Add session. The
Key Settings form appears.
Configuring L2TPv3 Tunnels
1
2
3
4
5
6
7
2. Tunnel ID Field 3. Remote Tunnel ID Field
Description
Default: true
Enables/Disables the tunnel
The local tunnel-id
Tunnel-id of remote tunnel endpoint
Ip address of local interface
Local listening transport port for tunnel service
Ip address of remote tunnel endpoint
The listening transport port of remote device for tunnel service
4. Local IP Field 5. Local Port Field
Chapter 5
Setup and Configuration
6. Remote IP
643