Enabling And Configuring Sftp Sessions - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
enabled
Listen IP
Listen Port
Extra IP:Ports
Maximum Number of CLI Sessions
Idle Timeout
Greeting
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
4.
to proceed.
Click Exit Transaction or continue making changes.
5.
Section 5.4

Enabling and Configuring SFTP Sessions

To enable and configure SFTP sessions, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin. The SFTP Sessions form appears.
242
Description
Default: true
Provides the ability to configure the device via CLI over ssh and serial console.
Synopsis: The ip-address type represents an IP address and is IP version neutral.
The format of the textual representations implies the IP version.
Default: 0.0.0.0
The IP Address the CLI will listen on for CLI requests.
Synopsis: The port-number type represents a 16-bit port number of an Internet
transport layer protocol such as UDP, TCP, DCCP, or SCTP. Port numbers are assigned
by IANA. A current list of all assignments is available from <http://www.iana.org/>. Note
that the port number value zero is reserved by IANA. In situations where the value
zero does not make sense, it can be excluded by subtyping the port-number type. In
the value set and its semantics, this type is equivalent to the InetPortNumber textual
convention of the SMIv2.
Default: 22
The port on which the CLI listens for CLI requests.
Synopsis: "extra-ip-ports" occurs in an unbounded array
The CLI will also listen on these IP Addresses. For port values, add ':#' to set the non-
default port value. (ie. xxx.xxx.xxx.xxx:19343 [::] [::]:16000). If using the default address,
do not specify another listen address with the same port.
Synopsis: unbounded
Default: 10
The maximum number of concurrent CLI sessions.
Default: PT30M
The maximum time before an idle CLI session is terminated. The default time is 30
minutes, or PT30M. A timeout period of 1 year, 1 month, 2 hours and 30 seconds would
be translated as P1Y1MT2H30S. The countdown will not begin if the system is waiting
for notifications or if commits are pending. Changes will not take effect until the next CLI
session.
Default: Welcome to Rugged CLI
Sets the greeting presented when the user logs in to the CLI.
Enabling and Configuring SFTP Sessions
RUGGEDCOM ROX II
User Guide