RUGGEDCOM ROX II
User Guide
Section 3.21.5
Adding a Serial Port Protocol
To add a serial port protocol, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2.
Navigate to interface » serial » {slot/port} » protocols, where {slot/port} is the slot name and port number
of the serial port.
3.
Click <Add protocols>. The Key Settings form appears.
Figure 123: Key Settings Form
1. Protocol Box
4.
Configure the following parameter(s) as required:
Parameter
protocol
5.
Click Add to create the protocol.
6.
Configure the protocol.
• For information about configuring a DNP protocol, refer to
• For information about configuring a Modbus TCP protocol, refer to
Modbus TCP
• For information about configuring a raw socket protocol, refer to
Socket
Protocol".
7.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8.
Click Exit Transaction or continue making changes.
Section 3.21.6
Configuring the DNP Protocol
To configure the DNP protocol for a serial port, do the following:
1.
Change the mode to Edit Private or Edit Exclusive.
2.
Navigate to interface » serial » {interface} » protocols » dnp » setdnp, where {interface} is the serial port.
Adding a Serial Port Protocol
1
2. Add Button
Description
Synopsis: rawsocket, tcpmodbus, dnp
Protocol".
Section 3.21.6, "Configuring the DNP
Section 3.21.7, "Configuring the
Section 3.21.8, "Configuring the Raw
Chapter 3
Device Management
2
Protocol".
123